We are looking for off the shelf Mobile Charger,description as follows: 1. Operating Voltage- 12V 2. Testing Voltage - 13.5V Hole dia 22mm & overall length 89mm. purchasing volume as attachment.

We require Hydraulic Lash Adjuster for our P15 Engine & the technical requirements is as below. Outside Dia – 35 – 0.025 / - 0.041 , Inner Dia – 33.35 + 0.25 , Width – 26 +/- 0.5 Oil Groove width –2.5 – 0.3 , Width 14.25 +/- 0.25 , Plunger travel – 0.5 mm , Test load – 1500 N, Temperature – 21 +/- 2 deg C Oil Viscosity - V20 = 70 +/- 4 mm2 /s Length with plunger fully bottomed – 16.35 + 0.25 / - 0.1 Length of plunger from top – 18.4mm Min Length with plunger fully expanded – 20.4mm Max

We are looking for Diesel Engine Assembly for our India commercial vehicles; 4 or 6 cyls;Euro II and above Emission Standards. Qulification of suppliers: 1. TS16949 at least; 2. Experience of car manufacturer; 3. Good communicate in English skill.

我们正在寻找国内优秀的气缸体配套供应商，缸径在102到105之间，为我们的柴油发动机配套服务。 供应商要求： 1. 最好有TS16949认证，没有的话实力特别强的也可以考虑； 2. 有相关配套经验。

我们正在寻找国内优秀的气缸盖配套供应商，缸径在102到105之间，为我们的柴油发动机配套服务。 供应商要求： 1. 最好有TS16949认证，没有的话实力特别强的也可以考虑； 2. 有相关配套经验。

我们要的供应商必须有VDA6.1或者TS16949.

要求供应商必须有VDA6.1 或TS16949。

We are looking for Spline Shaft supplier. Requirements are: 1. 有TS认证的花键轴供应商 2. 质量稳定，最好有自己的热处理线； 3. 价格具备很好的竞争力； 4. 可以用英语交流技术问题； 5 长三角的供应商； 6. 中等规模即可。

we are looking for supplier for Underdirve Shafts, pls check the drawings and RFQ. (1)TS 16949 (2)OE experience (3)Export experience (4)English Ability

we are looking for supplier for Input Shaft, pls check the drawings and RFQ. (1)TS 16949 (2)OE experience (3)Export experience (4)English Ability